![]() This ST button deals solely with the USB input and is designed for live streaming with the Yamaha MG10XU. Yamaha MG10XU Mon/ST ButtonĪs we touched on earlier, some mixers like the MG10XU use the ST button slightly differently it has a TO MON/TO ST button that toggles between sending audio to monitors/headphones and the main stereo mix. The channel and group ST buttons both remain turned off so that the announcement is not heard in the main auditorium. To do this, connect a mic to your mixer and press the group button. For example, you may only want to make announcements to the lobby. It’s possible to configure your audio mixer so that a group controls the output of speakers in the lobby or another part of the building. If you’re using a mixer in a church, school, or theatre, you may have audio sources running through your mixer that you don’t want coming out in the main mix. ![]() ![]() You click those down to send the channel to a group and then click the ST button for the group to send that sub-mix to the main stereo output. This is where those numbered buttons we spoke about earlier come in. When you have multiple mics coming into the mixer from a drum kit, it can make more sense to send all of those channels to a group where you can control the overall sub-mix with a single fader. When To Avoid The ST Button?Īvoid using the ST button when you don’t want the audio from that channel sent directly to the main stereo mix. Click the ST button if you want to send this audio to the main stereo outputĬlick the ST button on whenever you want that audio to be part of the main stereo mix.Click the PFL button and test the audio source to set the correct amount of gain.We fit it into our workflow like this:Īll faders and gain/level knobs turned down and all buttons in the up position. How To Use The ST Button?ĩ9% of the time, we want the audio from our channel to go to the main stereo output, so we use the ST button a lot. It often takes the form of a red toggle button and is situated with other numbered buttons that’ll we’ll mention again later. Typically, you’ll find the ST button near the fader or rotary knob that controls the level for each channel. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |